Transparency Issues.

[ToxicSkylinesMH10]

Hey guys,

Ive got a little bit of a transparency problem.

I am using Blender 2.49

This is an A-10 Thunderbolt II (retro)

I repainted it to very basic colors so that I could just make a repackaged pack.
The plane works fine in the actual game, however, the canopy will block out the cockpit when I look at it in preview mode.

Ive had this small issue before and Ive never actually been able to find a cure for it.

Here are some pictures of the plane in the Preview mode:





And here are some pictures of the plane in the actual game, right after preview mode:




This is some kind of error with the transparency once again, there is nothing wrong with the rest of the airplane.
If anyone can help me out, I would be grateful

Also, I noticed on my own, that sometimes, when I change the frame rate number and save it, it will sometimes change how the canopy appears and sometimes it wont.
It may have something to do with this?

[Martin-Dutchie]

This is caused by the fact reduce peep hole effect is disabled in preview mode. Try moving the transparent srf's to the end of the .dnm.

[ToxicSkylinesMH10]

Alright then, it sounds good

How would I go about moving the transparent srf's to the end of the .dnm?


And I appreciate it man
If anything right now, I understand it all better

[Martin-Dutchie]

In blender, haven't got the faintest idea to be honest. In DNMviewer, you can just drag all the transparent .srf's to the bottom.

[ToxicSkylinesMH10]

I guess I will have to try that then


Thank you so much man

[ToxicSkylinesMH10]

DUDE!! You are BEAST!!

It worked

THANK YOU !!!!

that was so much simpler than I thought it would be. I feel like an idiot


You're the best bro